 | ||||
| ||||
ITC Bridge > Instrumental Transcommunication (ITC) > Frequency Sweep | Radio Sweep Tuning > the ovilus 1 |
| | ||||
| ||||
ITC Bridge > Instrumental Transcommunication (ITC) > Frequency Sweep | Radio Sweep Tuning > the ovilus 1 |
| Moderated by: Vicki Talbott, Keith Clark |
|
||||||||||||||
| the ovilus 1 | Rate Topic |
| Author | Post |
|---|
| Posted: Jul 12th, 2008 09:34 PM |
|
1st Post |
|
billyd Member
|
I just purchased the ovilus 1, has any used this device. I turn it on and it makes sounds and if I switch it over it says words. There is also a dowsing mode. I'm really just into the evp portion. I've been recording EVP for 3 years and wanted to give this a try. any advice or instruction would be helpful. billyd
|
||||||||||||||
| |||||||||||||||
| Posted: Jul 13th, 2008 11:44 PM |
|
2nd Post |
|
Keith Clark Administrator 
|
Hi Billy, I have the Ovilus, and have been unsuccessful in receiving anything coherent or indicative of spirit communication out of it. If I had the choice, I'd sell mine. Otherwise, I'll keep it for nostalgia - and as a collector's item. Keith
|
|||||||||||||
| ||||||||||||||
| Posted: Feb 7th, 2009 08:54 PM |
|
3rd Post |
|
Ashtonford Member
|
I also purchased a puck from the same place and have found it useless
|
||||||||||||||
| |||||||||||||||
| Posted: Feb 8th, 2009 12:46 AM |
|
4th Post |
|
joecioppi Moderator 
|
Hi Friends, I built the "Talker" board and found it needed a strong adjustable noise source to get the best results. The Talker has the same SpeakJet chip as used in Ovilus and Puck. I built it into my Joe's Box and used the amp and speaker when switched over to the synthesizer chip. My box has an extra pot and external jack to feed the output of a vhf am radio signal from a sony portable to the Talker board. When the noise from offstation is adjusted the Talker talks a blue streak. The Talker board doesn't have words preprogrammed into it. joecioppi
|
|||||||||||||
| ||||||||||||||
| Posted: Feb 8th, 2009 09:36 PM |
|
5th Post |
|
ourobouros2k2 Member
|
I too have the puck, and while ecm mode spits out more gibberish than anything correlative, I love the datalogging aspect of it. That and emf triggered alarms and camera/audio triggers. Also, I saw on Bill's website where he might be closing up shop at the end of this year, so any products currently out there will only increase in value as they become scarce to come by. Joe that is an interesting idea integrating the talker kit with the box. I have been meaning to pick up a couple of the talker kits for awhile now, and I guess that I had better get on it. thanks ANDY
|
||||||||||||||
| |||||||||||||||
| Posted: Feb 9th, 2009 10:58 PM |
|
6th Post |
|
sparks Member 
|
Hi Joe, How did you interface the vhf radio into the Talker board? Via the speakjet chip serial port, or into the PIC "antenna" input? regards, JEFF
|
|||||||||||||
| ||||||||||||||
| Posted: Feb 10th, 2009 08:22 AM |
|
7th Post |
|
joecioppi Moderator
|
sparks wrote: Hi Joe, Sparks, The pc board antenna is connected to a 0-5v range A/D pic input. I used a 5k pot to reduce an external earphone output from the the old sony SW radio. Joe
|
||||||||||||||
| |||||||||||||||
| Posted: Feb 11th, 2009 12:52 AM |
|
8th Post |
|
sparks Member
|
Thanks Joe. Ive got one to finish off here, so I probably should think about external noise input rather than it trying to latch onto stray EMFs and do something. Do you get continuous phoneme outputs via your method, or does it have rests of silence in between bursts? JEFF
|
|||||||||||||
| ||||||||||||||
| Posted: Feb 11th, 2009 12:56 AM |
|
9th Post |
|
joecioppi Moderator
|
continuous
|
||||||||||||||
| |||||||||||||||
| Posted: Mar 21st, 2010 01:55 AM |
|
10th Post |
|
cressonaparanormal Member
|
So where can I buy one?
|
|||||||||||||
| ||||||||||||||
| Posted: Mar 21st, 2010 02:00 AM |
|
11th Post |
|
Vicki Talbott Moderator 
|
Digital Dowsing now has a hand held combo Ovilus/Puck that sells for $149 I believe. Vicki
|
||||||||||||||
| |||||||||||||||
| Posted: Mar 21st, 2010 01:39 PM |
|
12th Post |
|
Fox_Malder Member 
|
I have this program, but it does not work as EVP, that is a joke program.
|
|||||||||||||
| ||||||||||||||
| Posted: Mar 21st, 2010 04:02 PM |
|
13th Post |
|
Vicki Talbott Moderator
|
I know it doesn't work for me either, but some people love it. They take the one word responses as genuine relevant communication coming directly after their requests or questions. Oh well, each to his own. Vicki
|
||||||||||||||
| |||||||||||||||
| Posted: Mar 22nd, 2010 05:16 PM |
|
14th Post |
|
Fox_Malder Member
|
You are right my friend
|
|||||||||||||
| ||||||||||||||
| Posted: Mar 27th, 2010 08:50 PM |
|
15th Post |
|
joecioppi Moderator
|
I've been thinking about the ovilus and if I had one, I would try to use it near a continuous direct current electrical arc. Also,m an AM radio speaker playng static noise would also have a random emf field for the ovilus to pick up. The device needs a strong noise emf field in which to operate. Joe
|
||||||||||||||
| |||||||||||||||
| Posted: May 1st, 2010 05:04 PM |
|
16th Post |
|
Fox_Malder Member
|
IOvilus download free http://www.tmlink.ru/iOvilus-v1.46-Jayman.rar
|
|||||||||||||
| ||||||||||||||
| Posted: Aug 2nd, 2010 02:48 PM |
|
17th Post |
|
whisper Member 
|
Fox_Malder wrote: IOvilus download free http://www.tmlink.ru/iOvilus-v1.46-Jayman.rar What is this file for Fox?
|
||||||||||||||
| |||||||||||||||
| Posted: Aug 2nd, 2010 09:22 PM |
|
18th Post |
|
arizonaevp Member 
|
whisper wrote: Fox_Malder wrote:IOvilus download free http://www.tmlink.ru/iOvilus-v1.46-Jayman.rar Hello All, This appears to be the iOvilus which is an I-Phone & I-Pod Touch application. For more info: http://www.digitaldowsing.com/iOvilus L8tr, Ron
|
|||||||||||||
| ||||||||||||||
| Current time is 03:16 PM | |
| ITC Bridge > Instrumental Transcommunication (ITC) > Frequency Sweep | Radio Sweep Tuning > the ovilus 1 | Top |
