|ITC Bridge and iDigitalMedium.com are now VARANORMAL.COM Please visit: https://www.varanormal.com This site does not allow new registrations, and is now an online archive of a decade of Paranormal and ITC (Instrumental Transcommunication) experimentation from 2007 - 2016 We thank you for a wonderful decade! ~ Keith Clark & Ron Ruiz|
|Moderated by: sparks, mikesndbs, Keith Clark, joecioppi, Jeff, fratka, EVPDave, Dr. Heinz Doofenshmirtz, Dmaumau, Bruce, ArizonaEvp, takne_007||
|Raudive Diode|| Rate Topic
|Posted: Oct 9th, 2013 08:49 PM||
Not sure why the topic was closed; are some posts missing on it as well?
I have some interesting news on using even tap recorders...you dont need to use an external or even an internal mic for that matter - IE NO MIC needed !
I read one experimenter use a resistor on the input to load the mic input; typically it is a 600ohm so you dont burn anything out; and across the mic not the dc if there is one on the imc if it is 3 lead which some are.
I have yet to try this using multiple tape setups on one recording session.
As for the diode I have yet to work on it; I am finally working on this again soon and have my lab setup and will even be livestreaming (I posted my site elsewhere here).
The problem is getting so much radio interference; dont even use an antenna; spirit or entities are gonna be right on top of you ! Put the rig in a metal enclosure and connect that to a recorder and listen to it live; also use the 600ohm on the input so you would have to have a matching circuit so you dont load the transducer (diode/coil setup); you could use a battery and transistor amp setup to match it; theres a few ideas here...
As for noise just google noise types; possible filter for noise but dont forget noise is power and the entities need available power to manipulate into audio etc.
|Current time is 02:17 AM|
|ITC Bridge > Ask a Question, Give an Answer > The Technical Tower - A panel of forum members > Raudive Diode||Top|