View single post by clockdryve | |||||||||||||
Posted: Mar 9th, 2011 09:15 PM |
|
||||||||||||
clockdryve
|
mikesndbs wrote: Hi Here's something I found in file STE-000 It is in the area of 40 to 42 seconds. Sounds to me like a female voice saying "show me". It is actually a small version of a conversation going on from 34 to 44 seconds. I have LOOPED this smaller part to help pull out the female voice. I cannot understand what is said seconds before this voice, maybe instructions from a male voice, because I hear him speaking in 3 areas between those few seconds....female voice was last-just before the "blip" NOTE: when you are in an area that allows you LARGE amplification "not much QRM/QRN" (interferance) ....AFTER recording you can really slam it with a lot of amplification....*UPLOADING to PC (amp it) or while using your Audio Software during PC playback (amplify the complete recording) allowing the base band audio signal to be "as large" or a little larger than the height shown in these CAPITAL LETTERS. I'll show example. This is when you are using the Raudive Diode Receiver mostly.... because there isn't anything else in the way for distraction (much). NOTICE: This upload I sent here of the female voice is very quiet... It is the actual true volume of your recording...highlighted by looping only. I will include a version showing the allowed limit (close) to were you can amplify the file after (or during) upload to PC. *while you are working with the file to find the EVP's* I hope this is not confusing... what I am trying to explain. You should download and possibly "amp" this attachment "show_me....." to a level of volume you are more comfortable with.... but I wanted to show it's natural volume level so you can pinpoint the voice in your original recorded capture..... Attachment: show_me-LOOPED-evp.mp3 (Downloaded 1165 times) Last edited on Mar 9th, 2011 10:23 PM by clockdryve |
||||||||||||
|