 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Feb 7th, 2010 |
| Location: | Des Moines, Iowa USA |
| Posts: | 425 |
| Status: |
Offline
|
Attached Image (viewed 3369 times):
Last edited on Jan 31st, 2011 05:26 AM by clockdryve
| View single post by clockdryve | |||||||||||||
| Posted: Jan 31st, 2011 05:20 AM |
|
||||||||||||
clockdryve
|
If you want to try a different circuit...try this "less know" design from the attachment. It uses a different resistor and removes the coil and adds a capacitor...Be SURE you insulate the location where the "stiff" wire (straightened paper clip is fine) comes out of the metal enclosure so it doesn't TOUCH if you decide to use the metal. You can build this without the metal enclosure...but if you want it as original then it is to be included in BOTH designs. Attached Image (viewed 3369 times): Last edited on Jan 31st, 2011 05:26 AM by clockdryve |
||||||||||||
|
| |||||||||||||