View single post by ckmscott | |||||||||||||
Posted: Oct 15th, 2008 01:59 PM |
|
||||||||||||
ckmscott
|
Hi, I hacked my own 20-125. It is harder than the others, but not that bad. There are some good instructions on how to hack it here: http://www.keyportparanormal.com/simpleghostboxhack.html The only additions I have to those instructions are to place tape on those buttons at the top of the radio BEFORE you take the 20-125 apart. If those buttons fall out, it is a major pain to get them back in. Also, I wouldn't bother with pushing back the glue on the circuit board to cut the MU wire. I would just locate which wire it is and follow it to the middle of the ribbon cable. Cut into the plastic on either side of the MU wire with a small sharp knife. Be careful not to cut into any other wires. Then pull the MU wire out a bit and cut it with scissors. Pull both ends back to separate them and you should be set. Chris Last edited on Oct 15th, 2008 02:02 PM by |
||||||||||||
|