 |
PM |  | |
Quote | | |
Reply | | |
Full Topic | |
| Joined: | Jun 26th, 2009 |
| Location: | Heart Of Arizona Indian Country, Arizona USA |
| Posts: | 662 |
| Status: |
Offline
|
You don't need to apologize for anything. Post as many pics as necessary.
Finding the correct solder pads for the speaker should be a matter of visually tracing the negative runs coming off the power input.
Or...if you have a VOM multimeter, you can check for continuity from the negative pad of the power input to the speaker pads.
I had to mirror the one image of yours to get it to line up with the circuit board.
Once you find the negative pad for the speaker you will be good.
Here is a pic for reference:
Attached Image (viewed 267 times):