View single post by Grimus
 Posted: Apr 8th, 2014 07:12 AM
PM Quote Reply Full Topic
Grimus

 

Joined: Apr 7th, 2014
Location:  
Posts: 21
Status: 
Offline
 It is tough to tell if it is actually getting a signal if when I touch it, it does not hum.

Is this how everyone else here who is messing with this is determining if their setup is working?

---------
Edit: After checking, it hums when I touch it no matter which way the diode is pointing, which is odd because I thought the whole thing about diodes what that it only had a signal going 1 way. I must be messing up my terms... but how do you folks know if your set up is ready to get a signal?

Last edited on Apr 8th, 2014 01:21 PM by Grimus